Basic
Lightweight filler 12 kg
Item no. 1057
You use Basic to smooth wall surfaces before the look goes on. The lightweight filler is a plastic-based ready-to-use plaster with mineral fillers and comes premixed in a 12-kg container. Apply it in a thin coat, 1.5 mm at most. Above 2 mm, there is a risk of shrinkage cracks. We recommend Basic for waterproofed wall surfaces. Once fully cured, the surface is splash-proof and can take mechanical loads. In the wet area, you use Basic only as a substrate, with a non-absorbent layer such as T-Razzino+ 2K on top. We do not approve it for floors. Store the container tightly closed and protect it from heat and frost.
- Ready-mixed plaster: plastic-based with mineral fillers
- Wet areas: only under a non-absorbent layer such as T-Razzino+ 2K
- Thin coat: maximum layer thickness 1.5 mm
Price after account approval
Materea supplies applicators. With a valid VAT ID your account is approved immediately and you see all prices.
Register as a businessAlready approved? Log in
Basic lightweight filler
Price after account approval
The system build-up
Basic lightweight filler is layer one. You need the rest to go with it.
A surface lasts because the layers fit together. Everything here is matched to Basic lightweight filler and comes in one order.
The build-up for this surface
Before the look
First the substrate,
then the look.
Basic smooths waterproofed wall surfaces. Stir well, apply in a thin coat with the trowel, then the look goes on top.
- 3 Steps: stir, apply in a thin coat, smooth off
- 1.5 mm Maximum layer thickness, risk of shrinkage cracks above 2 mm
- 12 kg Container, ready mixed
Technical data & downloads
The figures for application.
All values come from our catalogue.
Application
Values and conditions
- Baseplastic-based ready-mixed plaster with mineral fillers
- Layer thicknessmaximum 1.5 mm, risk of shrinkage cracks if applied thicker than 2 mm
- Practical tipSmoothing waterproofed wall surfaces
Times until the surface can take loads
- Ready for loadssplash-proof and resistant to mechanical stress after full curing
Consumption and timing values depend on the substrate and the room climate. The values come from our catalogue.
Questions
What applicators ask about this.
Frequently asked questions
How thickly can I apply Basic?
Maximum layer thickness 1.5 mm. Above 2 mm, shrinkage cracks can occur.
Can I use Basic in the bathroom or on the floor?
Not on floors; we do not approve Basic for that. In the bathroom you use it to smooth waterproofed wall surfaces; once fully cured, it is splash-proof and can take mechanical loads there. In the shower and other wet areas, Basic can only be used as a substrate, provided a non-absorbent layer such as T-Razzino+ 2K goes on top.
How do I store the container?
Keep the container tightly closed and protect it from heat and frost.
What the surface still needs.
Primer and sealer are part of the build-up. The times given above apply to the fully sealed surface.
